So this starter isnt coming out. I dont know how much more cheater bar I need. But I know I dont have anymore. Im also at the point where id rather not Crack the housing. So what color loc-tite did these cunts use?
Niggas used jb weld
ive heated it as hot as a map gas torch can make it. tried a 3/4 Milwaukee impact, 6ft of cheater bar. Than bitch is either cross threaded or loc-tited.
@Evil_Bender @tyler If it was red loctite heat would have caused it to flow. Rocksett is the only thread-lock I know that can withstand heat from a torch but it's designed to be water soluble.
Have you tried a solvent or thread penetrator? Some Liquid Wrench or Acetone might do the trick. Soak it, rattle it as much as you can, and give it a few minutes, then try the wrench again.
Also, have you considered it could mother natures thread-lock, rust?
Have you tried a solvent or thread penetrator? Some Liquid Wrench or Acetone might do the trick. Soak it, rattle it as much as you can, and give it a few minutes, then try the wrench again.
Also, have you considered it could mother natures thread-lock, rust?
soaking it all weekend is my plan now
@Evil_Bender @tyler @GoonPatrol is there like an ultrasonic cleaning bath you could put it in to break shit loose
big enough for a class 8 truck, no
We shall see on Monday. Boutta spray all of it on 3 bolts
Follow
@Evil_Bender @tyler @dictatordave @GoonPatrol
Agricultural is on the can
Let's hope it is only used on stuff that does not touch the food
Also Marine it better just be used on ship parts inside the ship that do not get wet
Unless it also says non toxic or whatever
